Strip-N-Flash™ is a 40 mil. thick membrane consisting of a 32 mil self adhering rubberized asphalt laminated to an 8 mil high density polyethylene film. A silicone release liner prevents the product from sticking to itself in the roll. The factory-controlled quality assures uniform thickness on the job and the name Strip-N-Flash™ assures an excellent water barrier.
» Surface Preparation: Concrete shall be in place for 7 days minimum. Substrate must be completely dry. Surface shall have a smooth finish free of voids, sharp protrusions, laitance and form release agents. Block or brick walls shall have mortar joints struck flush.
» Primer: Surfaces to receive Strip-N-Flash™ must be clean and dry. For best results, concrete, masonry and some exterior gypsum substrates require coating with Primer. Apply Primer per manufacturer’s recommendations.
» Application: Precut Strip-N-Flash™ to fit each location. Remove siliconized release liner and position membrane carefully before pressing in place. Press firmly in place with a steel hand roller, taking care to avoid air pockets and wrinkles. Overlap adjoining pieces 2 inches. Cut bottom edge back 1/2 inch from exterior surface of building and place on drip edge. Be sure Strip-N-Flash™ is installed a minimum of four-inches above the mortar deflection.
» Terminations: Press termination edges firmly in place with a hammer handle or similar tool. The use of a surface mounted termination bar or placing the flashing membrane into a joint of the inner back up wall is recommended for vertical terminations. ABP End Dams are recommended at horizontal terminations.
Note: Failure to use adequate pressure at terminating edges will result in a poor seal and a potential leak.
Self-Adhering Flashings Thickness Roll Size Rolls Per Box Rolls Per Pallet UOM Strip-N-Flash™ 40 mil. 12” X 75’ 3 90 Sq. Ft. Strip-N-Flash™ 40 mil. 16” X 75’ 2 60 Sq. Ft. Strip-N-Flash™ 40 mil. 18” X 75’ 2 60 Sq. Ft. Strip-N-Flash™ 40 mil. 24” X 75’ 1 30 Sq. Ft. Strip-N-Flash™ 40 mil. 36” X 75’ 1 30 Sq. Ft.